• Tools You Will Need for Measuring Vertical Blinds:
  • A steel tape measure
  • A pencil for marking and writing measurements
  • A worksheet to note down your findings
  • A ladder if your windows are tall

  Tips for Accurate Measurements:

  • Be careful not to swap the height and width measurements, as this can result in a blind that does not fit.
  • If you are measuring multiple windows, do not assume they are all the same size. Measure each window individually, as even small differences can affect the fit of your blinds.

  Outside Recess Measurement

  To measure for an outside recess fit, check the exact area you want the blind to cover. To reduce light coming through, we suggest the blind extends at least 70mm above the window recess and 50mm on each side. The bottom overlap is up to you, but remember to consider obstacles like radiators. Always use a metal tape measure, as cloth tapes can stretch and give inaccurate results.

  Inside Recess Measurement

  If you want your blind to fit inside the window recess, measure the full width and height of the recess (essentially the window opening). We will make the necessary deductions to ensure your blind fits perfectly. Measure the width and height in three different places and use the smallest figure for accuracy. Do not make any adjustments yourself, as we will handle these to guarantee the correct fit. Again, a metal tape measure is recommended.

Before you start, ensure you have the parts that come with your vertical blind. You will also need:

Additional Equipment:

• Top fix brackets x2
• Face fix brackets x2
• Hangers x1
• Allen key x1
• Stabilising chain x2
• Safety hook x1
• Wood screws x4
• Weight x1
• Pencil
• Screws
• Drill with the correct bits
• Crosshead screwdriver
• Metal tape measure

Face Fixing Instructions

Place the brackets roughly 5cm from each end where the headrail will sit. If you have more than two brackets, space the extra ones evenly along the length of the blind. Make sure the fixings are suitable for the wall or surface you are using. Hook the back of the headrail into the brackets and rotate it into position. Secure the headrail by tightening the small screw at the front of each bracket.

Top Fixing Instructions

Measure and mark the positions to allow clearance for window handles or other obstacles in the recess. Position the brackets about 10cm from each end, with extra brackets spaced evenly if more than two are supplied. Ensure the fixings are appropriate for your wall or surface. Tilt the headrail and hook it into the bracket, then rotate it into place until it clicks. To remove the headrail, press the bracket at the designated point.