For Roller Blinds Only

Inside Recess Measurement:

To fit a blind inside the window recess, measure the full width and height of the recessed area, from wall to wall.

1. Take three measurements across the recess at the top, middle, and bottom.
2. Take three measurements down the window at the left, right, and centre.

Guide for Inside Recess Fitting:

• Use a steel tape measure for precise measurements in centimetres to the nearest millimetre.
• Measure width and height in three places and use the smallest measurement when ordering.
• The factory will make any necessary deductions for recess blinds to ensure a perfect fit.
• Take care around obstructions such as tiles, handles, or rails to ensure measurements are accurate.

Outside Recess Measurement:

If the blind is to be fitted outside the window recess, it will be made exactly to the measurements you provide, with no deductions.

Guide for Outside Recess Fitting:

• To block sunlight effectively, we recommend overlapping 6cm on each side and 7cm at the top.
• Measure the exact width of the area you wish to cover.
• Take care around obstructions such as tiles or rails to ensure accurate measurements.
• You may choose to overlap the bottom of the window if desired.

Please select your preferred mounting type:

Top Mount: Fitted to the ceiling or the top of the window recess.

Face Mount: Fitted to the outside face of the window frame.

Brackets must be positioned to allow the blind to operate freely. Ensure the blind does not hit handles or window fixtures. Loosely place both brackets on the blind and position it in the window to check alignment. This will make it easier to centre the blind correctly.

1. Place the control-side bracket on the same side as the chain mechanism. Mark its position carefully, making sure it is level and not twisted. Drill holes and fix the bracket using raw plugs if attaching to a wall.
2. Insert one end of the blind into the mounted bracket. Position the second bracket on the other end, mark it level with the first, then drill and fix it into place using raw plugs if needed.

Mounting the Blind:

• Insert the pin side of the blind into the pin-side bracket. The pin end has a spring mechanism to make mounting and removal easier.
• Insert the control mechanism into the control-side bracket, ensuring the central lug points downwards and hooks securely into the bracket.

Operating the Blind

Once installed, use the side chain to raise and lower the blind smoothly.

P-Clip Safety Device

• Install the P-clip as far from the control mechanism as possible to prevent the chain from becoming slack.
• Ensure the chain passes through the P-clip and is tight at the bottom of the loop.
• Secure the tensioning device along the wall to keep the chain taut from end to end. This ensures the blind operates safely and smoothly under constant tension.