Please provide the full wall-to-wall measurements for both the width and the drop of your blinds. The factory will make the necessary deductions for you. We cannot process or dispatch your order until the correct measurements have been received.
Our roller blinds are designed with a natural weave effect that adds a touch of style to any room.
Important: Please keep in mind that colours can look different depending on your screen or device settings.
Every roller blind is securely packaged with its fittings. Your parcel will include:
€ 46.69
Roller Only Measure
For fitting the blind inside the window recess, measure the full width and height of the recessed area from wall to wall.
Inside Recess Measurement
Take three width measurements across the top, middle, and bottom of the recess. Then take three height measurements down the left, right, and centre of the window.
Guide for Inside Recess Fitting
Use a reliable steel tape measure to take accurate measurements in centimetres, down to the nearest millimetre. You must measure in three places for both width and height and use the smallest figure when placing your order. The factory will make any deductions required for “recess specified blinds” to ensure they fit correctly. Be careful of any possible obstructions such as tiles, handles, or rails when measuring, as this may affect the fitting.
Outside Recess Measurement
When fitting the blind outside the window recess, the blind will be made exactly to the measurements you provide, with no deductions.
Guide for Outside Recess Fitting
Measure the area that you want the blind to cover. To reduce light entering, we recommend allowing an overlap of around 6cm on each side and 7cm above the top of the window. Measure the full width of the area. Watch out for any obstructions such as tiles or rails when taking the measurements. You can also choose whether you would like the blind to overlap at the bottom of the window.
Please choose one of the following fitting styles:
Top mount – fitted to an overhead surface such as the top of the window recess or to the ceiling.
Face mount – fitted directly to the face of the wall or outside of the window frame.
When positioning the brackets, make sure the blind can move freely without catching on handles, doors, or the window frame. Hold both brackets loosely against the blind and position them in the window to find the best placement. This helps centre the blind and makes installation easier.
Place the control side bracket on the same side as the chain mechanism. Mark the position of the first bracket, ensuring it is straight and not twisted, as incorrect positioning can stop the blind from working properly. Drill the holes and secure the bracket in place, using wall plugs if necessary.
Insert one end of the blind into the first bracket. Then place the second bracket on the other side of the blind and mark its position so that it is level with the first bracket. Drill the holes and fix the second bracket into place, again using wall plugs if required.
Mounting the Blind
Insert the pin end of the blind into the pin side bracket. The pin side has a spring mechanism that helps with both mounting and removing the blind. Insert the control mechanism into the control bracket as shown. Make sure the central lug of the mechanism points downwards and locks securely into the bracket.
Operating the Blind
Once fitted, the blind is raised and lowered by using the side chain.
P-Clip
This safety device must be installed as far as possible from the control mechanism to keep the chain tight and secure.
Ensure the chain passes through the P-clip and that it stays tight with the clip fixed at the bottom of the loop. This will allow the chain to move smoothly while staying under tension. Screw the P-clip securely to the wall in line with the blind, keeping the chain tight and firmly held in place.
