Please provide the wall-to-wall measurements for both the width and the drop of your blinds. The warehouse will then make the necessary deductions for you. We cannot dispatch your order until we receive the correct measurements.
Our roller blind has a natural weave effect that is perfect for bringing style into your home.
Important: Please note that the colour of the blind may appear differently on different screens or devices, depending on your display settings.
Our roller blinds are securely packed with all the required fixtures and fittings. Inside your package, you will receive:
€ 46.69
Roller Only Measurement
For fitting the blind inside the window recess, you will need to measure the full width and height of the recessed area (from wall to wall).
Inside Recess Measurement
Take three separate width measurements across the inside of the window recess: at the top, middle, and bottom.
Then take three height measurements: on the left, centre, and right side.
Guide for Inside Recess Fitting
Use a steel tape measure to obtain exact measurements in centimetres to the nearest millimetre.
Take measurements in three places for both width and height, and use the smallest measurement when placing your order.
The factory will make the required deductions for recess blinds so that the fit is precise.
Be careful when measuring around any obstructions such as tiles, handles, or rails, making sure the chosen position is correct.
Outside Recess Measurement
If you are fitting the blind outside the window recess, we will manufacture it to the exact measurements you provide, with no deductions made.
Guide for Outside Recess Fitting
Measure the area you want the blind to cover. To block out sunlight, we recommend an overlap of 6 cm on each side and 7 cm at the top. You should measure the full width of this area.
Take care to check for any obstructions such as tiles or rails so that the position is accurate.
It is your choice whether to allow the blind to overlap at the bottom of the window.
Please choose which fixing method you would like:
Top mount / Face mount
Position the brackets so that the blind can operate freely without hitting any handles or frames. Hold the brackets loosely in place to see where the blind will sit, as this will help you to centre it more easily.
Place the control side bracket on the same side as the chain mechanism. Mark where the first bracket will go, making sure it is level and straight to avoid problems with operation. Drill holes and fix the bracket securely, using raw plugs if fitting into a wall.
Insert one end of the blind into the mounted bracket. Then position the second bracket on the other side of the blind and mark its location, making sure it is level with the first bracket. Drill and fix this bracket into place, using raw plugs if required.
Insert the pin end of the blind into the pin side bracket. The pin end has a spring action that makes it easier to mount or remove the blind. Insert the control mechanism into the control side bracket as shown. The small lug on the control mechanism should point downwards and slot into the cross-shaped section of the bracket, hooking securely into place.
Once the blind is fitted, use the chain on the side to raise or lower it.
The safety device must be installed as far away as possible from the control mechanism to stop the chain from hanging loosely.
Make sure the control chain runs through the p-clip and remains tight. The p-clip should be positioned at the bottom of the chain loop while still allowing smooth movement. Screw the tension device firmly to the wall in line with the blind, ensuring the chain is kept permanently tight and under safe tension.
